Device Programmers
Stand alone programmer for different CPUs available
Once set up,Flasher can be controlled without the use of PC Program
Please visit this for more details.
The ONBP100 programs eproms, eeproms, flash memories or microcontrollers on assembled boards. It can also be used to program special purpose memory modules such as OBRMs. Typical applications are Avionics systems where eproms have to be soldered to the board. The programmer can cater for 8, 16 or 32 bit systems with or without parity. Purpose designed plug-in adaptors cater for each board type. The programmer is fitted with six power supplies to cater for almost all circumstances.
Lloyd Research provides a number of solutions for ’In circuit’ programming depending on the parts being programmed for examples Microchip PICs, Atmel AVRs, F5000 Fast In circuit programme and many more. Please check their website for more information. Once set up using a PC, the F5000 and H8000 do not need a PC as they can be controlled using their optically isolated logic interfaces. The more versatile F5000 can store multiple data sets for identical or different targets. The choice of target can be made using the logic interface or a software command each time a device is programmed at almost no time penalty.
The fxRAPIDO is a much faster programmer which makes it ideal for programming flash memory as well as small micros and eproms. It is fitted with a USB port which is about ten times faster than a 115K baud link to a PC. Also, increasingly PCs are not fitted with RS232 ports. Although the fxRAPIDO can be used stand alone, the PC utility supplied makes it easy for unskilled operators to repeat a job.
The programmers can be fitted with over 100 different gang plug-in socket modules (2 different ones shown) to cater for different families / packages etc.
The LabTool-848XP is a gang programmer, which works through your PC’s USB port or parallel port. It features 8 pcs fully isolated 48-pin ZIF sockets, extremely high throughput, standard 5V and 3V chip support, device insertion and continuity check. With PC-based design the device update through software gives customer more flexible and quick access to the new chip support. The LabTool-848XP supports EPROM, EEPROM, FLASH in the introduction. Future software update will include 87C5x, 89C5x , and PIC16Cxx microprocessor.
The PC2400 programmer is ideal for reprogramming non volatile memories (NVMs) in TV sets. Parts can either be programmed in situ or as components. Both DIL and SO parts are supported by the in circuit programming lead supplied. The programmer is hosted by a PC over a USB link making it ideal for use with modern portable PCs which may not have an RS232 port.
The LabTool-48UXP features universal pin driver, each pin can supply four different voltage, ground, it also can be configurable as TTL high/low levels with pull-high/pull-low, high-speed clock and high impedance. This advanced pin design lets you program any DIL device of up to 48 pins without needing an adapter.
LabTool-T400 Turbo Flash Gang Programmer is four sockets PC-based Gang Programmer. It features four independent isolated modules, extremely high speed in writing flash memory chip. It supports 3.3V, 2.7V, 1.8V and 1.2V chip in both VCC and I/O without low voltage converter and handles 8/16/32 bit flash chip in different package through adapter modules, up to 128Gb flash can be support. The LabTool-T400 is an ideal programmer for customers in GSM, 3G Mobile, PDA, Internet router and others